FFR Driveshaft Loop

Sub-Catalogs

  • 8.8" LIVE AXLE READY TO INSTALL 

    8.8" LIVE AXLE READY TO INSTALL

  • Products

    Safe!

    No Assistance Needed.

    Warning!

    Assistance Strongly Encouraged.

    Danger!

    Assistance Required.

    FFR Driveshaft Loop

    FFR Driveshaft Loop

    Made to fit all FFRs & coupes. Drilling required. NHRA thickness. Must drill .527" holes to fit

     

    $115.00

    YOU WILL NEED A DRILL BIT .525-531" DIAMETER. ALSO A 3"-4"  LONG 3/8" X 16 BOLT & NUT WITH FLAT WASHER.


    DRIVESHAFT SAFETY LOOP INSTRUCTIONS:

    WITH THE DRIVESHAFT INSTALLED TAKE YOUR SHARPIE AND MARK THE CENTERLINE OF YOUR FRONT U-JOINT.
    LOCATE THE D/S LOOP SO THE LOOP IS EVEN WITH THE FRONT U-JOINT CENTERLINE. 
    WITH THE MIDDLE OF THE D/S LOOP AND CENTERLINE OF THE FRONT U-JOINT ALIGNED, MOVE THE D/S LOOP 1/2 INCH REARWARD.
    MARK THE D/S LOOP BOLT HOLES ON THE FRAME RAIL. 
    DRILL THE HOLE ONE AT A TIME WITH .525-531" BIT.
    TAKE THE 3"-4"  LONG BOLT AND SCREW INTO RIV NUT.
    INSERT THE RIV NUT WITH BOLT, NUT & WASHER INTO THE DRILLED HOLE.'
    TIGHTEN THE NUT AGAINST THE WASHER & RIV NUT TO EXPAND THE RIV NUT. 
    REMEMBER TO MEASURE TWICE AND DRILL ONCE

    Product Inquiry

    Want to order or ask questions about this part? Please call 508-875-0016 or submit the form below.

    * Required





    Phone
    Email
    Either is fine